Attaching Vinyl Siding To Concrete Wall

Although the process of installing vinyl siding is relatively simple it helps to have assistance.

Attaching vinyl siding to concrete wall.

Is there any wood exposure with the concrete wall. I will be installing stained cedar siding on a new house being built with a walkout basement. There are at least three alternative ways to do it. Install another horizontal board along the top of the block wall and attach vertical boards at the.

If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. Installing vinyl siding over concrete is similar to installing it over wood since you have to install wooden furring strips under the siding. Use concrete screws to attach the boards to the block. Vinyl siding can give an ordinary concrete home an appealing polished look and update its appearance.

Vinyl siding unlike other types. A concrete block garage is just about as sturdy as any garage can be. The basement walls are 8 poured concrete walls with the back wall being framed. The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor.

The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. Installing 2 inch wide treated strips is necessary for a solid base for the house siding. This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. If so then tyvek it.

I will have a 4 retaining wall for wing walls. The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick. In effect i would need to add a bit of spacing between the concrete and the siding. The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house.

If you are useing a treated material for the fur strips then tyvek is pointless over concrete. If you are installing furring strips over the concrete you better either 1 use treated material for this or 2 put tar paper between the cement and furring strip. The backwall framing is framed against 8 walls that were not stepped down. As a result the osb protrudes about a half inch farther out than the concrete.